Heating radiators not heat up China Central Heating Radiator Manufacturer

Heating radiators not heat up

2021-12-22 11:16

Reasons and solutions for air blockage of home radiator

Air blockage of the radiator means that there is a large amount of air in the radiator. The reason is that gas will enter the heating pipe during the water supply process of the radiator. When there is gas congestion, the heating will not be hot. Therefore, the air release valve is one of the necessary accessories of the radiator, which is used to release the gas and make the heating system circulate smoothly.

Now there are two types of bleed valves: automatic bleed valve and manual bleed valve. The method of manual bleed valve to solve the air block is: use a screwdriver to loosen the manual bleed valve above the radiator and the air will be automatically discharged (air Always go upwards) until the water is discharged from the radiator, and then tighten the exhaust valve to close it.

Automatic air release valve, air release is completely automatic, without manual operation. Due to the high cost, there are few radiator manufacturers that have standard automatic bleed valves on the market. Only some manufacturers with large brands and strong capabilities have automatic bleed valves as standard. There are two types of automatic bleed valves: domestic and imported. The domestic automatic bleed valve is easy to block, dripping and leaking often occur during use, and the imported quality is relatively better. In 2014, the Rubens radiator was equipped with the world's most advanced automatic air release valve imported from the United Kingdom. It is fully automatic and intelligent for 24 hours. The room is warm for a long time. This automatic air release valve adopts a manual and automatic two-in-one design. , Double insurance, silent exhaust, completely solve the leakage and blockage of the domestic automatic air release valve, effectively prolong the service life of the radiator, and improve the heat dissipation efficiency.

The cause and solution of impurity blockage in heating pipe network

The impurity blockage of the radiator is generally caused by the radiator that has not been cleaned for many years, and there are too many impurities such as scale in it. If you want to heat up the heating in your home, you must clean the radiator to remove the dirt in the radiator. When cleaning the radiator, you must first dredge the pipes. If conditions permit, you can add a trap to filter the backwater, and it is enough to clean the trap filter regularly.

The above has introduced the solutions to the air blockage and impurity blockage of the radiator. Rubens radiator related people kindly reminded that when purchasing a radiator, it is better to have an automatic air release valve as standard, which allows the "radiator" to breathe freely, which not only reduces the heating The phenomenon of fin air blocking can greatly extend the service life of the radiator; long-term use of the radiator is easy to form dirt, and impurities must be cleaned regularly to ensure the heat dissipation function of the radiator.

Hot tags :

heat outputs column radiators uk designer radiators direct